Windsor TRACER FS QTFSG Uživatelský manuál

MODEL: TRACER FS QTFSD (Diesel Version) QTFSG (Gas Version) Operating Instructions 98349 11/01/03 M FLOOR SWE

CONTROLSQTFSG/QTFSD 98349 05/15/033-2The weighted root mean square acceleration at theoperator’s arms was measured to be below 2.5m/s2 forthe QTFS

CONTROLSQTFSG/QTFSD 98349 05/15/033-3A. Directional Control PedalB. Brake PedalC. Parking BrakeD. Operator SeatE. Rear Cover LatchF. Main Broo

CONTROLSQTFSG/QTFSD 98349 05/15/033-4A - DIRECTIONAL CONTROL PEDALThis pedal controls the direction of travel and thespeed of the machine.Slowly pre

CONTROLSQTFSG/QTFSD 98349 05/15/033-5I – HOPPER DOOR SWITCHThe hopper door switch opens and closes thehopper dump door. Pushing the front half of t

CONTROLSQTFSG/QTFSD 98349 05/15/033-6Q – CHOKE (GAS ONLY)By pulling this knob out, the choke is engaged forcold starting. To release choke, push th

OPERATIONSQTFSG/QTFSD 98349 05/15/033-7BEFORE OPERATING THE FS:1. Complete the machine data sheet on page 2.2. Read this manual carefully before o

OPERATIONSQTFSG/QTFSD 98349 05/15/033-8STOPPING THE MACHINE1. Remove foot from the directional pedal andapply the brake.2. Raise and turn off the

OPERATIONSQTFSG/QTFSD 98349 05/15/033-9TO DISENGAGE THE HOPPER SAFETY ARM1. Raise the hopper.2. Place the safety arm in its storage position onthe

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-1HYDRAULIC FLUIDHydraulic fluid is used with the hydraulic pump tooperate the hopper lift system and the side

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-2HYDRAULIC FILTERThe hydraulic filter keeps the machines hydraulicsystem clean to a level of 10 microns. The

MACHINE DATA LOGQTFSG/QTFSD 98349 05/15/032YOUR DEALERName: _______________________________________________________________________________________

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-3MAIN BROOM (Refer to the Main Broom Groupand Main Broom Lift Group in the Parts section)FOR SAFETY: The main

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-4CHECKING AND ADJUSTING THE MAIN BROOMPATTERN1. Using chalk, or similar material, coat and area ofthe floor

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-5SIDE BROOM (Refer to the Side Broom Group inthe Parts section)FOR SAFETY: The side broom automaticallybegin

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-6TRANSMISSION JACKSHAFT BELTThe transmission belt transfers power from theengine to the transmission jackshaf

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-7TO ALIGN BELT1. Repeat steps 1-78. Loosen tension on impeller drive pulley on endof transmission jackshaf

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-8IMPELLER BELTThe impeller belt transfers power from transmissionjackshaft to impeller.1. Turn off machine a

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-9DRIVE WHEEL CHAIN (Refer to the Front WheelGroup in the Parts section)The drive wheel chain transfers power

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-10REPLACING THE LEFT BROOM SKIRT1. Turn off machine and set parking brake.FOR SAFETY: Before leaving or serv

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-11HOPPER SEALSThe hopper seals prevent dust from exiting aroundthe hopper where it meets the broom chamber.Th

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-12HOPPER DOOR SEALSThe hopper door seals prevent debris from spillingout of the hopper before dumping. There

TABLE OF CONTENTSQTFSG/QTFSD 98349 05/15/03 3Machine Data Log...2Table of Contents...

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-13To clean the filter after removal, use one of thefollowing methods:1. TAPPING Tap the filter frame gently

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-14! WARNING! WARNING! WARNINGSPECIFIC GRAVITYBATTERY CONDITION1.265 100% CHARGED1.225 75% CHARGED1.190 50% C

HYDRAULIC SCHEMATICQTFSG/QTFSD 98349 05/15/034-15HYDRAULIC TROUBLESHOOTINGPROBLEM CAUSE SOLUTIONHopper will not liftLoss of power to rockerswitchKey

PROPEL SYSTEM TROUBLESHOOTINGQTFSG/QTFSD 98349 05/15/03 4-16PROBLEM. CAUSE SOLUTIONNo propelling Low battery charge Charge battery.Controller overhe

MACHINE TROUBLESHOOTINGQTFSG/QTFSD 98349 05/15/03 4-17PROBLEM. CAUSE SOLUTIONExcessive dusting Dust skirts and seals worn,damaged, not adjustedprope

MAINTENANCEQTFSG/QTFSD 98349 05/15/034-18SERVICE SCHEDULEMAINTENANCE DAILY WEEKLY 50HRSCheck and add fuel (see Engine’sOwner’s Manual supplied)*Chec

HOW TO USE THIS MANUALQTFSG/QTFSD 98349 05/15/03 1-1This manual contains the following sections:- HOW TO USE THIS MANUAL- SAFETY- OPERATION

QTFSG/QTFSD 98349 05/15/03 2-1IMPORTANT SAFETY INSTRUCTIONSWhen using a gas or diesel powered appliance, basic precautionmust always be followed, in

HAZARD INTENSITY LEVELQTFSG/QTFSD 98349 05/15/03 2-2The following symbols are used throughout this guide as indicated in their descriptions:HAZARD I

SAFETY LABEL LOCATIONQTFSG/QTFSD 98349 05/15/03 2-3NOTE: These drawings indicate the location of safety labels on the Tracer FS. If, at any time,

SAFETY LABEL LOCATIONQTFSG/QTFSD 98349 05/15/032-4NOTE: These drawings indicate the location of safety labels on the Tracer FS. If, at any time, t

TECHNICAL SPECIFICATIONSQTFSG/QTFSD 98349 05/15/033-1ITEM DIMENSION/CAPACITYPower Source: Gas 20hp, 2 Cylinder, Liquid-Cooled